Updating the released version of Multitone to the latest,
v1.0.50. This is the same as the preview version of 1.0.50 with the addition of a small cosmetic change to correct the units displayed in the labels on the sweep plots.
Changes in 1.0.50
- Add: support for dBV, dBW, V, and W display units with Amplitude Voltage (FS) and Resistance calibration settings
- Add: support for creating custom Frequency-Modulated (FM) test signals and adding a couple of FM test signals to the drop-down list
- Fix: reprocessed data from history entry didn’t quite match the original measurements due to lower number of averages
- Fix: history click/unclick sometimes selected the previous entry even when the checkbox was not clicked
- Fix: color selection dropdown in history sometimes required two clicks
- Fix: switching to Spectrum plot after a sweep, but with the sweep still selected, and then performing a measurement would do a spectrum analysis instead of the sweep
FM test signals are specified by entering FM at the start of the line, followed by three numbers: the carrier frequency (Fc), the modulation frequency (Fm), and the frequency deviation of the modulating frequency:
FM 1k/200Hz/900Hz
FM 3k/50Hz/10k