Latest activity

Amen. This racket of creating a new DSP innovation and then having AV manufacturers require everyone buy a "whole 'nuther receiver"...

Seems like you could not use this speaker system without these units.

200 hz is really too high a crossover unless your using really small mains, like under a single 6" woofer. The great majority of systems...

I'm disappointed. The results are not quite perfect. Sigh! I suppose considering the free software and modest hardware expense it is...

If you have two USB DACs that are running on their own clock they will go out of sync rather quickly. At least in Mac there are ways to...

Not a good plan to 'Y' or 'Wye' two outputs into one input. Each of the outputs will see the other output as a low impedance load. It...

Wives can do that.

So, not ready to call the distortion issue officially fixed, but we are very comfortable that we have found the culprit. We have a few...

I’m a big fan of XT32 and iOS editor app too. (esp. with Ratbuddysey). I had the NR1608 and X3500H backed by Accuphase amplification...

This plot shows THD and THD+N vs. frequency of NC252MP at very high power 240W/4ohm. Please note the loss of maximum clean power at...

I contacted Focusrite and they told me only the 18i20 and the Clarett models have anti thump technology. The clarett pre 2 and 4 models...

Νο

Hi Don, I'm counting on the same thing with my Denon avr-x8500h and KEF R500 front speakers. According to the soundstage measurements...

I have never posted about this, because I cannot find the thumb drive that contains all the data and photos, so I have nothing to share...

Ask SMSL directly what the actual IC is. You have every right as a purchaser and repair person to obtain the appropriate service...