I don't get it..
I haven't talked about it for a while...
pointed out for a while that wiim aware and will settle it..
and finds satisfied that probably settled...
since 03/11
I would like to point out that some users refer that bit perfect reproduction via toslink verification tests on RME ADI-2 and other gears, is lost. Deviations are especially for anything over 44.1/16. Can someone verify and provide? Bit perfectness was the main reason to use wiim... thanks in...
wiim.community.forum
we, and wiim, know ....
and I just hope I don't have to take time with this kind of situation anymore...
ps
to help because I'm not concerned.. I spoke with the support of wiim about the clipping problems on the eq mode... in May...
(
as a reminder of this story, "the ramblings" of onlyonme or me and a few others, the tons of messages..measurements etc
we were essentially to try to explain the thing, to invite others to verify our statements, etc.
especially on a forum like asr!
while at the same time some bit perfect test in hand would suggest that we were morons etc.
So started from something not very important that just had to be checked and settled by wiim..
to end up with an infinite waste of time.. and pass for a "bore going around in circles"
for information
the eq function has existed since the beginning and it is by trying to circumvent the clippings on this mode which has also existed for months.. that they included drc... and that we unfortunately also left in the no eq mode. ..
moreover, as we can see, this drc hardly works even in eq mode.
I would have done better to keep it quiet...