room correction

Introduction This is my first post after I have been reading and benefiting from this forum for roughly two years. I am no trained listener, and I listen to music purely for pleasure. Thus, everything I post should probably be taken with a grain of salt. Nevertheless, my impressions and...

Hey folks, after some reading I have two rough ideas for a setup and would love some input from you knowledgeable people. background: Went into the store and auditioned the kef ls50 w ii, and ls60 and was blown away by both, with a preference for the ls60. However, I would like whatever I buy...

I have asked several people this, and they either are not explaining it so I can understand, or they just don't know. Because when I probe further they do not reply. Please help. I was going to purchase EverSolo DMP-A10 (DAC/Sreamer) and use it strictly as DAC/Streamer and NOT a preamp...

I have decided to go with 2 subs that apparently have a fair bit of delay due to all of the processing they do. (KEF KC92). Someone recommended to use the miniDSP 2x4 HD, as it not only does room correction, but also has adjustments for speaker delay. However, the miniDSP 2x4 HD does not have...

I am buying a 2 channel stereo system that consists of an integrated tube amplifier, and a streamer/dac that has no room correction, and speakers, where all these sound great together. My brother also has the exact same system and it sounds great both at the stereo shop and his house. The...

Hello all! Long time reader, first time poster here. About 4 months ago I took the dive and purchased Dirac Live RCS. I had just moved houses, upgraded to a new pair of monitors, and put all my acoustic treatments up. Anyway, I've been living with it since then and I can totally hear what its...

Hi All Firstly, thanks for all the feedback on my previous posts. With the exception of a couple of people the constributions were very helpful.... Further to my last post, I've purchased the MA-1 mic and carried out some room correction with my Neumann KH120ii's. The results were excellent and...

I've been playing around with my MiniDSP2x4HD and four subs to simultaneously optimize both frequency response and impulse response. I wrote an optimizer to simultaneously optimize for both. This is what Dirac Live does for speakers, and possibly for subs with Dirac Live Bass Control (DLBC), but...

Hi all!, Like the title says, I need some help with placing acoustic panels in my room, I made some rough rendered images of my room and they should have all the information you need about measurements, any information about where to place panels is greatly appreciated. I'm not trying to make my...

So, we (Sigberg Audio) have speakers and subs with built-in manual EQ, which is great - but we have many customers who doesn't know how to and/or doesn't want to learn how to use REW and a microphone to measure their system. Even though most here on ASR might find that to be "easy" and "worth...

Hi. I have seen many posts and articles where they show how to analyze and get flat response curves for speakers. However, none of them show how the frequency response of a well treated room looks like. Then I found this video: And from what I understand is that, flat frequency response studio...

Hi all, after allot of lurking around I've decided to create an account. Mostly because I could use some insights on buying a new integrated amp. My current setup consist of the following: - Harman Kardon BDS, used as a pre amp for digital sources. - Sony ES integrated stereo amp, used as...

Dear ASR community, I'm a new member. Most of the time I listen to music from Qobuz, with my integrated streaming amplifier Yamaha R-N803D, feeding a pair of Kef LS50 Meta and the active subwoofer Kef KC62. I've been thinking of upgrading to Nad c399, but I'm not fully convinced and I shall...

Hi folks, My KEF LS50W Nocturnes crapped out ($2500, active) and I'm looking for a replacement. My request is that these are: - nearfields (sitting ~3ft away), - functional close to the wall (3-5 inches of separation). - active, or if passive, the price of a good amp can fit in the $5k I...

Hey all - so I’m totally new to PEQ/correction, etc. Done a bunch of reading and searching but still not exactly clear on this and how to generate the files. Here is what I’d like to do: I have an Eversolo A8 and I’d like to use its DSP to do room correction when I’m playing digital. I have...

Hello, I have been tweaking my new AVR (Integra DRX 8.4) setup and it has Dirac and DLBC options also. Firstly, I optimized my placement the best I could without any room correction and then I used room correction to see if gets any better. I would like to understand why Dirac is behaving the...

Just saw this yesterday on RME forums and thought it was exciting news: (full source) Preview: I can only hope this functionality finds its way to Babyface and ADI-2 DAC successors some day :) EDIT [2024-01-25]: Seems UCX II support was added as well; updated title accordingly.

This thread is mostly directed at @OCA to continue YouTube comment section discussions in a little easier format, but maybe it will be helpful to others. First system I'm working on is my office desktop setup, in a carpeted bedroom that's approximately 4.7m x 4.1m x 2.9m. I live just under...

Hi all! I’m thinking about adding room correction to my setup and am wondering what’s the best way to go about it? My searches have led me to a number of things that seem like they might be out of date so I figured I would just ask. I currently have a NAS and a Logitech Music Server...

I currently have the XLR output of the Gustard DAC going to a Buckeye amp and it works well. The way I integrated the sub is with high level (speaker wires) since I don't have a receiver with LFE output and DSP room correction and speaker volume adjustments. I have the sub crossover dialed in...