- Thread Starter
- #21
Thanks for the overwhelming amount of help. It's getting late and the bed is calling anyhow tomorrow I'll:
1) Move the sub along the wall with the driver facing 1/3 and 2/3 width directions.
2) Move the sub to a corner and try to see what happens. Hopefully less null and more eq cutting.
3) Investigate that 500hz dip (and perhaps the 4k/10k hz mess depending on measurement).
... And post the proces. Maybe someone will get the same problems as i face with subs and nulls in the future.
However even though its low cut its quite easy to hear its direction including it being just beside the table (instead of under). Phase switch (to 180hz) didn't work. It moved the null up a bit.
Again thanks for all the help and lovely to see the community alive against which i presume to be a common enemy: Nulls![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
1) Move the sub along the wall with the driver facing 1/3 and 2/3 width directions.
2) Move the sub to a corner and try to see what happens. Hopefully less null and more eq cutting.
3) Investigate that 500hz dip (and perhaps the 4k/10k hz mess depending on measurement).
... And post the proces. Maybe someone will get the same problems as i face with subs and nulls in the future.
However even though its low cut its quite easy to hear its direction including it being just beside the table (instead of under). Phase switch (to 180hz) didn't work. It moved the null up a bit.
Again thanks for all the help and lovely to see the community alive against which i presume to be a common enemy: Nulls