Guys, I could really need some advice (electrics noob). The DC-Offset topic concerned me and I just grabbed a multimeter and measured the volatage between pin 2 and 3 of the male xlr-preouts on the back.
Since I powered it on about 15 minutes ago the values constantly creep up and seem to stabilize around -137mV on the left and -97mV on the right channel. Is this something to worry about? Directly after powring on, it shows positive values, crosses zero pretty fast and then continues to drift into negative values.
I cannot stick those "measurement needles" (don`t know the english word for them) into the female balanced headphone out directly, because the isolationis too thick but on the other side of a 4-pin-xlr to 3,5mm jack it only reads 9mv on one channel and 15mV on the other, so much lower values. uCorrection below. Also big offset here... (-128mV, -81mV) With out put set to pre-out, it has a slight positive offset.
Any advice, if I need to be concerned? Thanks!
Since I powered it on about 15 minutes ago the values constantly creep up and seem to stabilize around -137mV on the left and -97mV on the right channel. Is this something to worry about? Directly after powring on, it shows positive values, crosses zero pretty fast and then continues to drift into negative values.
I cannot stick those "measurement needles" (don`t know the english word for them) into the female balanced headphone out directly, because the isolation
Any advice, if I need to be concerned? Thanks!
Last edited: