Hello Amir or Peng Haber if you can help me since I read you a lot and see that you handle all the records.
I just sent my avr20 to the arcam sat because from the first day it gives me the feeling that the preout outputs cover my subwoofer and
the stage I use for the 4 atmos.
The sat told me that it was all correct and within the values given by the manufacturer but it did not give me any proof of it, and asked to measure the output voltage of an avr it is not necessary to reset it
and leave it from the factory?
Then something is happening with my subwoofer and it is that with my old denon 8500 the sub was set to -25db and that was enough and with the avr20 I have to raise them to -15db to sound similar and the current stage
I use for atmos something similar happens!
The gain is 26db and 1v does this influence what I noticed at low volume?
Greetings
I just sent my avr20 to the arcam sat because from the first day it gives me the feeling that the preout outputs cover my subwoofer and
the stage I use for the 4 atmos.
The sat told me that it was all correct and within the values given by the manufacturer but it did not give me any proof of it, and asked to measure the output voltage of an avr it is not necessary to reset it
and leave it from the factory?
Then something is happening with my subwoofer and it is that with my old denon 8500 the sub was set to -25db and that was enough and with the avr20 I have to raise them to -15db to sound similar and the current stage
I use for atmos something similar happens!
The gain is 26db and 1v does this influence what I noticed at low volume?
Greetings