Reviving this thread, hopefully, I bought a ICE 125asx2 kit from soundimports.eu but there are no sound in the attached speakers when testing. The wiring are the same as in post #312. It is running “SE”.
I’ve tried to feed it from the pre-outs of my Denon x3700h, directly from a Bluesound Node, and even my phone’s jack. When output volume on the source devices are cranked to the max I can hear barely audible sound in the speakers mixed with noise. Using an IR thermomotor, there is heat around the output circuits on the board, some 40-50 Celsius, so there are power around. When switched off, there is a little puf in the speakers, but that all.
I really can’t see that I’ve connected any wires wrongly, but of cause possible. There are not any shorts between the inputs, outputs and ground, nor between any terminals.
Does anyone have any suggestions?
Is it a DoA, return to sender board I’ve got – or can’t I use connect the tested inputs due to low voltage or similar?
Thanks,