This is a review and detailed measurements of the Project Pre BOX DS2. It is a multi-function device with USB DAC, headphone amplifier, analog pre-amplifier with Bluetooth, and phono stage. It is on kind loan from a member and costs US $899 although I see some open box ones for US $699.
The DS2 manages to come across as elegant in a sea of same looking desktop audio products:
View attachment 78769
The controls are microprocessor based and have a good feeling to them. LEDs light up to indicate what mode the device is in.
The back panel better shows all the functionality:
View attachment 78771
I don't care for membrane based remote controls but that can be easily replaced with another remote. The power supply is nice and light although has those adapters for mains socket which I don't fond of. But I understand the usefulness of it instead of stocking multiple versions of the unit.
USB DAC Audio Measurements
As usual, let's start with our dashboard view of a 1 kHz digital tone fed to the unit:
View attachment 78772
Wow, I must say, whenever I see a multifunction device I expect its DAC to be mediocre but such is not the case here. SINAD (sum of noise and distortion) is quite respectable here:
View attachment 78773
Distortion is below -112 dB which assures transparency.
Dynamic range has good headroom above CD/streaming content's 16 bit requirement:
View attachment 78774
Intermodulation distortion versus level is competent as well:
View attachment 78775
Jitter performance is good:
View attachment 78776
As noted, there is a resampling feature (to high rate PCM and DSD) which I tried in this one test and it seems to be transparent.
There are four filter settings if you turn off resampling:
View attachment 78777
Two of them are sharp and two are slow as you see.
Preamplifier Audio Measurements
Our test here is similar to DAC except that now the source is a superbly high quality sine wave out of my analyzer:
View attachment 78779
Wow, this is very good again! Worst case distortion spike is again below -112 dB. SNR is not as good as the digital input but still respectable:
View attachment 78780
Frequency response is dead flat (good):
View attachment 78781
And distortion+noise are frequency independent:
View attachment 78782
Phono Preamplifier Measurements
Here is the same test yet again but with phono input:
View attachment 78783
Distortion is comfortably low at -100 dB. Noise however is elevated and was highly dependent on how I grounded the unit. So actual performance may be better or worse for you. As is, the high level of noise limits ranking:
View attachment 78784
Headphone Amplifier Measurements
Once again, same test but with headphone output:
View attachment 78785
This is OK performance but let's see how much power we have:
View attachment 78786
Not bad at all. This should enable it to drive high impedance headphones with good amount of loudness.
Performance suffers fair bit with lower impedance though:
View attachment 78787
Conclusions
The phrase "digital divide" definitely applies to audio electronics in that DACs with some rare exceptions don't have analog inputs. This forces people like me who have an alternate analog input (in my case, a Reel to Reel tape deck) to use an external preamplifier just for this one feature. So it is great to see a company tackle this market and importantly, not just go for feature checklist but actually deliver on performance. And good looks.
While not state of the art in any category,
the performance of the DS2 is competent and at times impressive enough to get my recommendation.
-----------
As always, questions, comments, recommendations, etc. are welcome.
Garden chores are killing me. Have a ton of harvest that needs preserving. I think we are average 20 zucchinis a day! Need money for supplies to preserve all of this so please
donate generously using
: https://www.audiosciencereview.com/forum/index.php?threads/how-to-support-audio-science-review.8150/