Acording to Hypex, both NC250MP and NC252MP have the same specs, at the exception of the power at 8 Ohms (130W vs 150W).
Ah ok, I thought maybe being monoblock, there
might be a small increase to ~96 or so. Thank you, I guess I will consider the NC400 then...but then R900 has high sensitivity and relatively speaking, the benefit of NC400 over NC250/252mp is in 2Ohm availability, which is unnecessary for R900?
No, you are actually pretty right about the "being pushed over max limits" part - it protects against exceeding current and heat limits, it just doesn't necessarily protect the speakers.
My apologies for my previous message being rather short and snappy, I was in a bit of a hurry.
No worries, written format leaves out
a lot of context. I'm just glad people are willing to donate time to answer questions at all.
The protection circuitry is independent of those above units, and one must purchase separately and attach? The one offered to me are finished ghentcases, so maybe better to start fresh. Do the FusionAmp plate amps have them? If so:
- Can I turn 2x FusionAmps into 2x monoblocks, since it even has DSP control? I would only need 2-way FusionAmp for the low/high FR? I assume I will have to drill the plate onto something...maybe the front and back of my old ATX tower, or acrylic panels from Home Depot for a
"modern" look? haha
- Could someone point me to some threads to turn a plate amp into a monoblock? I assume people have done this before, but I don't know what terms to search. I guess I would like to understand how to rework circuitry to produce a speaker outputs for LF and HF. Do you have to rework crossover, or would the internal crossover of the speaker be doing that? Anything else I may be missing.
Thanks again.