Julf

Which is also rare.

How do you determine what the optimal "correction" value is? BER measurement at the SPDIF receiver? Eye diagram? If you get drop-outs...

Exactly.

1) Cables don’t affect the sound meaningfully so you should save your money on things like speaker or room upgrades. 2) You need cables...

With low impedance source and termination (speakers, power cable), that becomes quite unusual.

Interconnects usually involve circuits with high impedances, which allow outside noise sources to modulate the signal which is not all...

Interconnects are normally shielded, for a good reason. Why wouldn't you use a shielded cable? On speaker cables, on the other hand...

Many interconnects are of coaxial construction. Shield as ground and center as positive. Like RG6. Interconnects don't have a sound.

Buckeye says you can just use an RCA>XLR cable

As a confidence builder why not email Purifi or one of the better amplifier builders like Buckeye Amps (USA), BoXem or Apollon (EU) or...

Normally, I look at performance, features, and price (and maybe appearance, etc.) and I don't worry about what's inside. It's 2024...

Compare it to a standard PASCAL switcher, just for grins.

Truly shocking for a product in this price bracket. "Probably one of the best power amplifiers ever built" "Gryphon have always said...

It was the binding posts, not XLR connectors. The original binding posts were ferrous, causing slightly higher distortion. That was...

Actually, XLR connectors had nothing to do with lower measurements on the original Buckeye Purifi design. The cause was steel hardware...