Yamaha MX-2 terminal change

[Knobstler]

Is there a way to change the binding posts on my Yamaha mx2 to accept banana plugs or spades instead of bare wire?

 

[staticV3]

Yes of course.
You can remove the cover, desolder the stock connectors, find suitable connectors of your preferred type, and solder them onto the PCB instead.
You may have to modify the rear face plate to make the new connectors fit.

 

[Knobstler]

Yes of course.
You can remove the cover, desolder the stock connectors, find suitable connectors of your preferred type, and solder them onto the PCB instead.
You may have to modify the rear face plate to make the new connectors fit.

Oh i was hoping there was a way withouth soldering. I guess i have to find someone who can do that or i leave it as is

 

[Elitzur–Vaidman]

Oh i was hoping there was a way withouth soldering. I guess i have to find someone who can do that or i leave it as is

What about something like this: https://a.co/d/eHB4clT
Not the most elegant, but it would let you use banana plug cables.

 

[Knobstler]

What about something like this: https://a.co/d/eHB4clT
Not the most elegant, but it would let you use banana plug cables.

I was thinking about those aswell but i think they are for clamping terminals. Mine are screwed

 

[Zek]

Could something like this be used?

 

[Knobstler]

Could something like this be used?

I ordered spades before but they were too big. I think the european version of the mx2 can only accept bare wire

 

[Knobstler]

problem solved I found some smaller spades from viable which fit like a glove