
Universal Buffer
Fully differential buffer which provides a differential (balanced) and a single-ended (unbalanced) output with extremely low distortion. Great building block for a DIY preamp.

Thanks for sharing. It's another very good option.![]()
Universal Buffer
Fully differential buffer which provides a differential (balanced) and a single-ended (unbalanced) output with extremely low distortion. Great building block for a DIY preamp.neurochrome.com
I would buy a fully assembled board today.
Coupon not workingCan now be pre-ordered with 20%$ off, coupon code is "rcaxlr"
![]()
Stereo RCA to XLR Converter Module - RCA To XLR Converter
Ultra-high performance, fully transparent RCA to XLR Converter Module. Ready to be integrated into your DIY audio project.orchardaudio.com
That coupon expired a long time ago but I have re-enabled it for you through July 14th. Please note that I do not have stock of the bare boards only the fully assembled modules.Coupon not working
Ok so i can use this between my unbalanced out preamp and a balanced amp?That coupon expired a long time ago but I have re-enabled it for you through July 14th. Please note that I do not have stock of the bare boards only the fully assembled modules.
That's exactly what it is for.Ok so i can use this between my unbalanced out preamp and a balanced amp?
What is the benefit over this?That's exactly what it is for.
What is the benefit over this?
Ok. And can I use it without the enclosure?There are three ways to get from RCA (unbalanced) to XLR (balanced)
(1) Use an RCA to XLR adapter (this is what you have linked to above)
With an RCA to XLR adapter, you break the balanced input on your amplifier or pre-amp because 1/2 of the XLR input is shorted to the RCA’s shield. Depending on the design of the balanced input this can have undesirable effects.
(2) Use a transformer-based RCA to XLR Converter
A transformer-based converter can work well as long as it is properly matched to both the RCA and XLR side impedances. However, even if it is properly matched the transformer creates AC coupling which causes bass phase shift.
(3) Use an active converter (this is the product)
With a DC-coupled active converter, all the issues associated with the first two approaches are eliminated.
You can (I do not recommend that) but will also need to supply your own 9V power supply. When you buy the finished product the 9V power supply is included.Ok. And can I use it without the enclosure?
I'm super poor, but I have this one would it work?You can (I do not recommend that) but will also need to supply your own 9V power supply. When you buy the finished product the 9V power supply is included.
I don't know about that one but this one will work:I'm super poor, but I have this one would it work?
Ok thx. And I can just keep it plugged in forever?I don't know about that one but this one will work:
so will this one:
YesOk thx. And I can just keep it plugged in forever?
No, as long as you use the paired RCA/XLR connectors.Does it matter where the right/left channels go?
1A is enough.Also what's the current requirement - I have 2x 9v adapters one for 1A and one for 2A. Which should I use?