Hi. Thanks for answering and the provided link.
I already read
@amirm 's comment you refer to. Nonetheless, I assume that the statement applies when the connected device has an input impedance comparable to amirm's measuring equipment.
I am not sure about the typical input impedance of a powered speaker set and how this compares with amirm's device, hence my question.
Actually I am rather satisfied by the sound I get at both 50% and 100%, but was curious to understand whether I am putting my DA3's output stage (or the Lonpoo's input) at risk by using the DA3 at 100% and keeping the LP42X at low volume level, or if this can introduce some distorsion - even if light, or if it is better to keep the DA3 at 50% and increase the volume on the boxes.
Acoustically, given that most of the hearings originate from compressed audio, it is difficult to get any sensible comparison
Best regards
merak2000