I would run it and see what happens, checking with a REW measurement at the end.Unfortunately, I can't get any further because I don't know where the error is. The 5 KH80DSPs all have the same settings and I have also set them to the factory settings.
The Tascam 208i has 8 line outs and when I switch the speakers to these the "error" appears, see picture, but in the software of the 208i everything is set to the same settings.
Do any of you understand, this is now my 2nd attempt with a different interface and it still doesn't work. View attachment 333318
Extremely disappointing. Have you tried contacting Neumann?I can't get any further with the "result" at this point, i.e. it's impossible to go any further.
I don't understand why the 2 channels have such a low level, everything is at the same volume etc.
Did Neumann say with which interface it should work?I had emailed Neumann about the interface I had before for testing, but apparently it was completely unsuitable and was not recognized by the MA1 software. So it became the Tascam, which is now recognized but has these signal level problems. Factory settings loaded on all new devices, also on the interfaces etc. I have now ordered a 3rd interface and hope that it will work. It can't be that difficult to simply pass on signals via the outputs out of the box.
I'm convinced of Neumann, including the MA1 etc. Everything was easy to use before and there were only one or two teething troubles. Nothing that couldn't be solved quickly and easily. But this multichannel story of only needing one interface with 6 outputs, which are necessary for 5.1 calibration, well, yes.