Hechtschnitzel
Member
- Joined
- Dec 14, 2024
- Messages
- 31
- Likes
- 13
Hello Guys,
I’m looking to experiment with a 3D-printed 3-inch subwoofer and need a small, suitable amplifier for it.
The subwoofer has a 4 Ohm impedance, with 15W RMS and 30W peak power. Tang Bang W3-1876S
I’ve already connected a pair of Swissonic A305 active monitors via RCA (Chinch) from my PC. Now, I’m wondering how I can integrate the subwoofer into the setup. Do you think it would make sense to build an active subwoofer and simply split the RCA signal, or is there a better solution for my situation?
I’m open to any recommendations, as I don’t know much about this topic yet.
Thanks in advance!
I’m looking to experiment with a 3D-printed 3-inch subwoofer and need a small, suitable amplifier for it.
The subwoofer has a 4 Ohm impedance, with 15W RMS and 30W peak power. Tang Bang W3-1876S
I’ve already connected a pair of Swissonic A305 active monitors via RCA (Chinch) from my PC. Now, I’m wondering how I can integrate the subwoofer into the setup. Do you think it would make sense to build an active subwoofer and simply split the RCA signal, or is there a better solution for my situation?
I’m open to any recommendations, as I don’t know much about this topic yet.
Thanks in advance!