hunchojacques
Member
- Joined
- Sep 30, 2021
- Messages
- 5
- Likes
- 1
Greetings all....in the process of setting up KEF LS50W II's and two Rythmik L12 subs in my den. Carpeted room, square shape, 14X14. I've read so much in terms of opinions, set-up ideas, recommendations....that in all honesty, I'm actually more confused than I thought I was when I began this project.
So....from a question standpoint, I'm trying to get a grasp on settings for speakers vs. subs:
- Do I need a specific type of miniDSP or a Speaker Anti-Mode to get things set-up 'appropriately'?
- Any ideas on high and low pass frequencies on the LS50W II app settings?
- Any suggestions for Wall mode/Treble trim/Sub gain on KEF Connect?
- Should I use LFE on the Rythmik's vs. the L/R lines? My understanding is that I apply a crossover filter via the subwoofer signal path using the KEF Connect app, and the L/R's would create multiple crossover filters.
- PEQ Gain (On/Off & Settings), Bandwidth, Frequency, Delay/Phase, Crossover, LPF Slope, Bass Extension.....admittedly, zero understanding if I should mess with these on the back of the Rythmik subs, and how they interface with speaker settings.
I apologize in advance for some of these questions that I'm sure seem rudimentary to those in the know.....but figured this was the best place to ask. Any guidance is sincerely and greatly appreciated.
So....from a question standpoint, I'm trying to get a grasp on settings for speakers vs. subs:
- Do I need a specific type of miniDSP or a Speaker Anti-Mode to get things set-up 'appropriately'?
- Any ideas on high and low pass frequencies on the LS50W II app settings?
- Any suggestions for Wall mode/Treble trim/Sub gain on KEF Connect?
- Should I use LFE on the Rythmik's vs. the L/R lines? My understanding is that I apply a crossover filter via the subwoofer signal path using the KEF Connect app, and the L/R's would create multiple crossover filters.
- PEQ Gain (On/Off & Settings), Bandwidth, Frequency, Delay/Phase, Crossover, LPF Slope, Bass Extension.....admittedly, zero understanding if I should mess with these on the back of the Rythmik subs, and how they interface with speaker settings.
I apologize in advance for some of these questions that I'm sure seem rudimentary to those in the know.....but figured this was the best place to ask. Any guidance is sincerely and greatly appreciated.