Any point in using PO100 Pro with JDS Labs Synapse USB isolator for Holo Audio Cyan 2?

[4D_Coaxial_Cube]

I know the jitter from the USB input on the Cyan 2 is very low, but I was curious if there would be any point in using the SMSL PO100 Pro DDC with a JDS Labs Synapse USB isolator between it and laptop then running out of the PO100 Pro with I2S to Cyan 2. Any insights appreciated and thanks.

 

[staticV3]

No point whatsoever.

If you're struggling with ground loops, the Synapse alone would do the job.

The PO100Pro would serve no purpose in your setup.