pre-amp

Hello all, I’ve got a mindwrenching situation which I cannot seem to find the answer to. I’ve got a Yamaha A-S1100 integrated amp, and a Yamaha RX-A4A receiver. I’ve got a BK PB12 subwoofer that has SpeakOn and L/R RCA-jacks. One is for LFE the other in case you use a pre-amp with L/R pre-out...

SOLD About 10 years ago I had it serviced. There was an intermittent switch (listening) that needed cleaning. Other than that, it has worked flawlessly. Great phono stage. I have the original oem packaging for this.

Hello, just recently started getting more into audio with speakers/amplifiers, please bear with me as all of my equipment is currently from my dads basement... So what Ive started off with is a speakercraft big bang 12 channel amp, (images will be linked below.) Now, this does work in power the...

After finally getting my NADC3050LE delivered, there were a couple of things I wanted to understand in relation to the analog input and preamp outputs, as I need to use both: run a separate phono preamp into the line in and drive a separate amp from the preout. Consequently I wanted to verify...

Hi i would like to know some options for a decent pre amp with variable high and low pass filters. I have seen Emotiva PT2 has this feature (for example) but I am struggling to find others. Do you know of any you might recommend? £1800 max would be the budget.

Apologize if this is a dumb question, but most of what I can find online applies to multi-channel setups with surround processing and whatnot. I use my floorstanders in a 2-channel home theater type setup where we watch a lot of movies, stream television, and casually listen to music as well...

Hi all, I recently acquired a Thorens TD 280 MKII. Quite a newbie, but have a good ear, so like to set up the best possible setup for my budget. Since I can get a Denon DL-110 for quite cheap (200€) I'm now also looking for a pre-amp which would suite this setup quite as well and would be around...

Hello forum! I'm finishing up my new project for a stereo system for my living room and I'm going crazy with the last piece of the puzzle: the streamer/DAC/pre-amp. I have an amplifier and a pair of speakers and I am delighted with the set. I need a source to act as a streamer, DAC, and...

Hi all, I've had an Electrocompaniet ECI-3, a Rotel RCD-991 and Dynaudio Contour 1.3 MKii speakers since 2000 and it's all worked pretty well for what I've listened to (mostly progressive house, rock and singer-songwriter). However, I've always found that perhaps the amp had a little too little...

Hi, I am new to Hi-Fi audio and I have decided to spend some savings and build a mid-range system for LPs. These are the components that I plan to put together (please if you have different suggestions feel free to comment): Pro-Ject Debut Carbon EVO DALI OBERON 7 Cambridge Audio CXA81...

Firstly I'd again like to say thankyou to everyone involved with ASR for making HiFi fun again. TLDR: If I split the output from a preamp (for example with a Y-Splitter cable) do I need to worry about impedence and/or voltage level? Some may have noticed my desire to have tone controls. I...

Hey guys, First time posting here! I've been lurking around since 2017 something and created the account last year I think. Anyhow! I am looking for advice as there is a jungle out there on the market and the master review index isn't helping me for the moment. What I have today: Mains for...