Hello everyone!
I have a problem with my D10bal..After turning on the PC (Win 10) and starting playback in Foobar, no sound from the D10bal. The last driver 5.27 was installed, this was the same with 5.20. Everything seems normal, playback runs with all indications, but no sound. The only thing that will help is to disconnect / connect the USB cable, as some kind of reset. Then everything works normally. 2-3 months everything worked normally, the problem appeared gradually about 1 month . Now it's permanent. Has anyone encountered this, what is the possible problem?
I purchased the D10B last August and have continued to use it, but recently I have noticed that I have the same symptoms as you.
I start the PC and play music, but the display shows that it works perfectly, but there is no sound from the TRS analog output. At this time, the OPT/COAX output will be output normally without any problem.
I investigated to find out the cause. The findings are as follows.
If you connect and disconnect the USB cable several times, it will operate normally.
Symptoms do not always occur. Occurs on a whim.
The symptoms are the same even if you change the USB port of the PC.
This phenomenon occurs only on one of the two PCs.
D10s does not have this symptom at all. Occurs only on D10B.
It does not depend on the type of audio player on your PC.
The same symptom was reported in the Japanese Topping forum.
From the above, it is considered that there is some problem in the circuit operation of the power supply to the D10B or the analog output.