Did the reset work?
No, I left it unplugged a few minutes and confirmed it was in Player mode, then redid it again to put it back to Preamp....no luck, still the same issue.
Did the reset work?
Ok, sounds like it’s defective. Did you get it new?No, I left it unplugged a few minutes and confirmed it was in Player mode, then redid it again to put it back to Preamp....no luck, still the same issue.
And you also confirmed the same issue when not using Bluetooth, right?
And the radio had the same issue?I'm going to this morning (well I have tried it with the radio stations in the app), fixing to hook a turntable with built in phono up to it.....first I'm fixing to reinstall the latest firmware and see if that fixes anything. Then I'm going to plug it into a different receiver.
And the radio had the same issue?
It’s defective.Yes.....even when using the devices actual knob to control volume.
And the radio had the same issue?
No problem taking banana plugs. I took a closeup. Excuse the mess, I’m running 4 speakers in the kitchen off this unit.Are the speaker inputs binding posts that you could use banana plugs with to passive speakers? The manual shows just raw speaker wire when I looked on the Yamaha site.
Thanks for sending that! Thinking of getting one mainly as a compact amp for the computer desk to run through a JDS Labs Element as the pre amp to either KEF q150 or KEF LS50 's. Would be interested in what you are powering them too, I guess I should look through your older posts also. ANyways thanks again!No problem taking banana plugs. I took a closeup. Excuse the mess, I’m running 4 speakers in the kitchen off this unit.View attachment 72021
I’ve got two WXA-50’s, and three WXC-50’s, plus a MusicCast AVR, WX-010 & Soundbar (eight zones).Thanks for sending that! Thinking of getting one mainly as a compact amp for the computer desk to run through a JDS Labs Element as the pre amp to either KEF q150 or KEF LS50 's. Would be interested in what you are powering them too, I guess I should look through your older posts also. ANyways thanks again!
Nice that is good to hear. I don't have much experience with amps and passive speakers as I have always had powered speakers at my desk so I don't really know what to expect for amplification. Thanks for your feed back. Now to decide between the KEF's and ELAC DBR62s.I’ve got two WXA-50’s, and three WXC-50’s, plus a MusicCast AVR, WX-010 & Soundbar (eight zones).
As far as the WXA’s go, I’ve got four speakers hooked up in the kitchen (one pair Paradigm H65 IW’s and one pair Monoprice 8” IC’s). It’s never struggled driving them.
The other is hooked up to Tannoy Mercury bookshelf’s in one of my kids room. I don’t think you’ll have any issues driving the KEF’s, even though the amp is only 50 watts / channel.
This is what you can do with the sub.I have a question about subwoofer management. Is it possible to specify cut off point for low frequencies (eg 80 Hz) so that main speakers don't play below these frequencies? Can it be customized (eg in steps of 10Hz)?
2.1+EDR is correct. How can they use that in a 4 yr old product (note: none of these are good reasons) 1) their main competitor SONOS had no Bluetooth, so they probably thought that is a win. 2) most people don’t care 3) they don’t consider this their flagship and want you to buy the RX-A3080 which has Bluetooth 4.2What is the version of bluetooth in this device?
For a product that sells as a wireless streaming device, the bluetooth doesn't have any info in the marketing material. Someone in reddit mentioned Bluetooth 2.1+EDR. Is that really true? How can a 14 year old specification be used in a flagship product that launched 4 years ago?
Not sure if MusicCast is important or not to you, but all Yamaha’s AVR’S have MusicCast built in and most have lots of subwoofer filters, PEQ, etc. These amps cost $499, so look for a used AVR. There’s a RX-A2070 on eBay right now for $750.Thank you for this. That's disappointing. Search continues