I'm trying to put together a linear power supply for a TPA3255 board. I ordered a transformer from a company who shall remain nameless. It's 500VA and 34V transformer. They have two at these specs. One simply has 2x outputs at 7.4A (according to their specs). The other one has 2x 34V at 5.8A, 2x 12V at 2A, and 2x 18V at 2A.
I wanted the former (I only want the 34V out), they sent me the latter.
I sent them a message and they replied saying that both transformers are the same Spec, that I should just cut off the extra output wires on the one I received.
According to their specs, the latter transformer can output fewer amps at 34V. Is this assuming some kind of load on the lower voltage outputs? Should I just bite the bullet and use the one they sent me, or should I make them take this one back and get the one I intended to order.
Thanks a bunch
I wanted the former (I only want the 34V out), they sent me the latter.
I sent them a message and they replied saying that both transformers are the same Spec, that I should just cut off the extra output wires on the one I received.
According to their specs, the latter transformer can output fewer amps at 34V. Is this assuming some kind of load on the lower voltage outputs? Should I just bite the bullet and use the one they sent me, or should I make them take this one back and get the one I intended to order.
Thanks a bunch