Does anyone use DX3 with Raspberry Pi (for instance, MPD, Rune or Volumino)? If you do, could you please check if you can play this DSD512 file smoothly?
I know DSD512 is unrealistic for listening but since Topping support that it's worthwhile to check.
On my computers things are working fine. But on Raspberry Pi seems I can hear a lot of pops, probably due to USB noise.
I want to know if I'm the only person who experience this problem.
I'm using Raspberry Pi 3 Model B.
CPU utilization is always below 15% so I know I'm not throttling the CPU.
I benchmarked my SD card average reading speed of the same file is around 20MB/s so I know 50Mb/s / 8 = 7 MB/s is far from the top speed.
Redbook (44.1khz, 16bit) also experience the issue every few minutes but it's much more pervasive when playing DSD512.
I talked about this issue in this post but I'd like to see if it's my own problem or DAC's problem.
I know DSD512 is unrealistic for listening but since Topping support that it's worthwhile to check.
On my computers things are working fine. But on Raspberry Pi seems I can hear a lot of pops, probably due to USB noise.
I want to know if I'm the only person who experience this problem.
I'm using Raspberry Pi 3 Model B.
CPU utilization is always below 15% so I know I'm not throttling the CPU.
I benchmarked my SD card average reading speed of the same file is around 20MB/s so I know 50Mb/s / 8 = 7 MB/s is far from the top speed.
Redbook (44.1khz, 16bit) also experience the issue every few minutes but it's much more pervasive when playing DSD512.
I talked about this issue in this post but I'd like to see if it's my own problem or DAC's problem.