Hi @hteavnafets,Thanks for providing the clue to the problem, our software engineering found the problem and finished looking to fix it.One question. How should the sgd1 react if i generate the Hotspot ANIG? In my case all LEDs will go on. Connect with the Hotspot. After a while a restart is triggered. And then it will Do it again and again and again. Till i deactivate the Hotspot. Did i something wrong?
--------------------
2020-05-28
VER: 1.0.2.2
CHANGE:
1.Fixed restart issue after upgrade (when SGD1 is connected to the Internet for one minute after the upgrade is completed).
2.Optimize filter mode (set new mode to be saved after 3 seconds delay) occasionally save failure problem.
--------------------
You can use our simple factory upgrade mode to upgrade SGD1 system firmware:
1. Set mobile phone wifi hotspot, Name: ANIG Password: 12345678
2. Power off and restart, wait a few seconds, SGD1 panel lights are all bright, wait a few seconds, then restart, upgrade was successful.