Lucy
New Member
- Joined
- Jan 14, 2019
- Messages
- 4
- Likes
- 1
Very kind of youWelcome to the forum. Just ordered it from Amazon. Says will be in stock on the 18th and get to me by 21st....
Very kind of youWelcome to the forum. Just ordered it from Amazon. Says will be in stock on the 18th and get to me by 21st....
Even has a AC3 / DTS decoder =oHow about this one with also AD conversion? Swissonic HAD-1, 129€
https://www.thomann.de/fi/swissonic_had_1.htm
It only goes up to 24 bits/96 kHz. Not that you need more than that but means that it is an old design.How about this one with also AD conversion? Swissonic HAD-1, 129€
https://www.thomann.de/fi/swissonic_had_1.htm
I just shipped an amplifier to its owner and it cost $50! The AVRs are even larger and heavier. The cost to send them back and forth is very high.Home Theater AV Processor measurements!
It is pretty expensive at $400. Wonder if someone has one that will loan it to me for measurements.How about the iFi xDSD?
Did you by any chance ordered the Sony NW-A45 that I mentioned before? There are no measurements of Sony DAPs anywhereWelcome to the forum. Just ordered it from Amazon. Says will be in stock on the 18th and get to me by 21st....
Hum... I owned the DAC-9 during 1 year (driving 2 STA-9 amps) and had a very bad experience about the USB Input. This is not at all "isolated" or such and take the 5V power from the computer.
Once I turned on my PC, I heard a very audible "pink noise" in my speakers. Even worse when my PC was loading or gaming (or use USB transfer to external hard drive), all of these electronics noises were audible via the DAC-9. Nothing to complain about SPDIF inputs, though. I end up by using a Aune X1S as an USB to COAX interface to solve the issue.
I would like to se this as well in measurements. Or maybe my unit was defective.
Hum, you probably didn't get much noise from a Pi. I used mine with a high-end gaming PC. Of course the noise was from PC itself but I had many others USB DACs which didn't show this issue in the same scenario. Without a doubt, better USB isolated, galvanic or such things...neither ADI-2 DAC or Cayin iDAC-6 or Qutest, for exemple.I use Pi as source and connected through USB, didn't have any noise problem you described.
No I did not. Issue is that I have so much gear to measure that I don't feel good about buying more where interest may be limited. I am keeping it in mind though.Did you by any chance ordered the Sony NW-A45 that I mentioned before? There are no measurements of Sony DAPs anywhere