Post it - it is all good.
OK, both of these used the Parts Express "knock-down 0.56 cu ft" pre-cut box (16" tall, 8.5" wide, 11"" deep, just needed to be glued together). Not exactly art, but working very well.
Here's my 2nd Generation DIY speaker uses Purifi 6.5X mid/woofers and RAAL 70-20XR ribbons, ported on the top to get a long enough port tube, like 13" total:
...and here is my 3rd Generation (just finished), with the Purifi 6.5X aluminum mid/woofers and RAAL 140-15D ribbons, with no port/sealed:
The 3rd Gen speakers are my "best detail" speakers, but for my living room I'm planning this summer on doing a next gen after this with dual 6.5M mids and a special order super-tall RAAL dipole ribbon (8.25" ribbon, 14" total!), will probably need to be about 30" tall total: