I must not have discriminating ears, as I can't hear any distortion on any of the 3 modes.
Assuming they have managed to actually purchase something more brokenI can understand that, might be hard to do though. Because then the users would have to play back the sound through their DACs & Amps to see if the other DAC or Amp is musical ;x
The distortion is also volume dependent. It could be that you are not running it at as high a level as Amir is, in which case the distortion components may be low enough not to be audible.I must not have discriminating ears, as I can't hear any distortion on any of the 3 modes.
The distortion is also volume dependent. It could be that you are not running it at as high a level as Amir is, in which case the distortion components may be low enough not to be audible.
Not saying its bad, but being level dependent the gain of the remaining audio chain after the preamp may limit how high a level it can get to. The tube section goes to some absurdly high output level, even for XLR. Even then the THD+N is about -55 or so, which is borderline for audibility depending on what you are using for listening (speakers, headphones, etc.). The tubes could also vary from unit to unit as well in how consistent they are, how many hours they have, etc.Trust me, I've listened at extremely high volumes but at those volumes my ears were ringing anyway so detecting distortion was impossible. At normal to high listening levels (with well recorded music) I cannot detect any distortion whatsoever-again probably due to my 63 yo ears and the combination of components in the chain. Bottom line-I'm very happy with the Freya+.
I was not talking about reviews, I was talking about measurments. I trust the data an APx555 is plotting, it is not a matter of trust, it is a matter of double checking the measurments parameters and conditions. Yes they will vary and you can't draw straight comparison if they are not the same, but one can do the extrapolation with a bit of analysis.
Is this pronounce "shit"?
Yes, that is our name. Shih-tah. It's a proud German name, host to a long line of audio engineers who slaved away in crumbling Teutonic fortresses as lightning lashed the dark lands outside, working to perfect the best amplification devices in the world...
Or, well, no. Yep, Schiit is our name, and it's pronounced, well, like "hey man, that's some really good Schiit!"
I cannot see anything there for this model... got a link for that?Schiit publish the full Audio Precision measurement report of their products right on their website
I'm pronouncing it as Aww "Sjiiiit"Is this pronounce "shit"?
I cannot see anything there for this model... got a link for that?
JSmith
You can't compare raw measurements and a-weighted. They produce different results especially when power supply noise is present (as in tube mode).Don't quite understand this. Schiit showed much better SNR with their measurements. 115db and 120db for the tube and transistor, A-weighted.
For only 1.2kCool, a noise and distortion generator.
Haha perhaps at some point, for now I think I will have to take your word for it!@TK750 study some drawing/drafting stuff and go full isometric on life for weeks and see what you think after..., It's a rush!
It might be that your headphone isn't resolving enough, or the music you are testing with isn't recorded well enough. Or you aren't listening hard enough. it all depends lolApparently, at this time, 4 people in the poll own a Freya+.
I am one of them - and really like the sound, but maybe my 53 y/o ears can't her the distortion? I also use KEF Q350s, so seems I dig poorly rated stuff.
Thank you @amirm for all of your hard work and reviews!