If one were thinking of assembling a 3-channel Purifi amp out of three EVAL2 units, would a SMPS3KA400 be an appropriate power supply to use instead of wiring up three separate ~600W power supplies?
Would it make sense to try to mount the EVAL2's vertically to save width, or would that result in a unit that is too tall for common aesthetics? 35mm vs 59.5mm, but in reality you'd save less space because some of the savings would be taken up by a vertical mounting plate. It'd also result in the onboard XLR connector having its tab at the left or right instead of "top" unless you remove them from the board.
Would it make sense to try to mount the EVAL2's vertically to save width, or would that result in a unit that is too tall for common aesthetics? 35mm vs 59.5mm, but in reality you'd save less space because some of the savings would be taken up by a vertical mounting plate. It'd also result in the onboard XLR connector having its tab at the left or right instead of "top" unless you remove them from the board.