fluid

No, my interest is in waveguides and speaker design, not the drivers themselves. It isn't a topic discussed much, the tools and skills...

I've got Don's VACS file with the CTA2034 weights in it. VACS is very powerful but an awkward program to use, it needs some forward...

I did not create the video I linked. If you can create your horn design in Ath, it is coded to take advantage of Gmsh and produce a good...

There is a pretty good example of how to use Gmsh in this youtube video. There are lots of options and features that can be used to...

You can use this Fusion add on to turn splines into polylines for DXF export...

The mesh size sets the size of the triangles used for the surface model. This sets the high frequency limit of how accurate the results...

Thank you Fluid

Orcaslicer has built in calibration routines for it, then you store the values in your filament profile. You literally pick which line...

Did you tune pressure advance too?

It literally means that the elements of the mesh are too close together for the solver to give a reliable result. Using more subdomains...

Yes, Horizontal and vertical to compare against CTA2034 plots. Horizontal is in the ball park, vertical looks like the origin point is...

In that case why not export dual plane data at 5 to 10 degree intervals and see if it looks like other measurements of your speaker?

It looks like you have been able to separate the outgoing waves and the error is below -20dB almost everywhere which is good. Are you...

There is more than one Klippel machine. The laser isn't normally part of the NFS package and there doesn't seem to be a module for...

A new term :)