cany89
Active Member
- Joined
- Dec 22, 2020
- Messages
- 251
- Likes
- 127
Hi everyone!
I’m looking for a device that takes the XLR out of my preamp, split it to 4 XLR (2x for bookshelfs so XLR to power amp, 2x to active subs XLR or RCA). Then I need crossover, delay, and convolution filter for each output. So that I can set delay to bookshelfs if needed, and use impulse response file for both room correction and my studio monitors.
SHD got these features and many more, but I really don’t want to pay for all these unnecessary features. Anyone know a unit with only 2x4 + DSP features?
I got JBL 705i + 2x subs, and just getting 2x SVS 2000 to replace my crappy 8 inch subs. Using the subs crossovered around 180 hz and place them near JBLs. I will measure it once I got subs but I assume I will need some delay on 705s to match them with the subs. Any comment is welcome here as well…
Thanks!
I’m looking for a device that takes the XLR out of my preamp, split it to 4 XLR (2x for bookshelfs so XLR to power amp, 2x to active subs XLR or RCA). Then I need crossover, delay, and convolution filter for each output. So that I can set delay to bookshelfs if needed, and use impulse response file for both room correction and my studio monitors.
SHD got these features and many more, but I really don’t want to pay for all these unnecessary features. Anyone know a unit with only 2x4 + DSP features?
I got JBL 705i + 2x subs, and just getting 2x SVS 2000 to replace my crappy 8 inch subs. Using the subs crossovered around 180 hz and place them near JBLs. I will measure it once I got subs but I assume I will need some delay on 705s to match them with the subs. Any comment is welcome here as well…
Thanks!