For those of you who have two subs, is bass produced in stereo? If so, then the bass from each sub is slightly different from one another?
Isn't bass sort of non-directional... less pin-pointed than the higher frequencies?
My Martin Logan Dynamo 1100x is capable w/ an optional transmitter. I was concerned about latency?
I've been testing these pairs in a search for a wireless surround option for my family room. I have a pair of these same Dynasty units (v2) on the way and will post my results.I use the Dynasty WSA-5TR-V2 for 2 subs. It is dual band 5.2/5.8, stereo and supports multiple receivers per transmitter.
It uses the same module as KEF KW1 internally, but at a much lower price point.
WSA-5TR-V2 Wireless Subwoofer Speaker Kit, 5.2G / 5.8GHz Dual Band Sel
Tired of running cables around doors or hiding under carpet to connect your powered subwoofer to the receiver? Or having limited options on powered subwoofer (or active/powered speakers) placement due to cable length and component location? The Dynasty ProAudio WSA-5TR-V2 with Dual Band as 5.2 /...dynastyproaudio.com
Eager to see the results of the Dynasty units. I’ll be using wireless transmitters for rear surrounds, rear heights, and a pair of subs. Love to see full bandwidth results.I've been evaluating these wireless units over the last week. I have this dynasty one on the way today.
I've been testing these pairs in a search for a wireless surround option for my family room. I have a pair of these same Dynasty units (v2) on the way and will post my results.
I purchased a YMOO transceiver pair... this one...
Well, I can't recommend it. OK latency. FR not suitable for subwoofer duty. FR curve could be tolerable for surrounds. But poor noise floor, dynamic range and lots of distortion with simple HD and two tone IMD...
similar results with both 2i2 using rightmarkaudio and clio...
In the case of the rightmark data, the better comparison curve is the loopback of the 2i2.
In the case of the clio, the better curve is, again, the internal loopback of the clio setup.
over 10 dB down at 20Hz... Ouch...
Lots of higher order products even with a single 1k tone. Inputs not overdriven. 0.4v/0.775/2 tried as drive level. All with similarly poor distortion numbers.
Let's hope the Dynasty does better.
I have a teardown pix of this box. But, well, all the chip info is removed. Not surprising...
+1Eager to see the results of the Dynasty units.
Anecdotal PSA:
Tried a 1Mii wireless transmitter with an AIYIMA two-channel amp for a recently purchased pair of surround speakers. No signal and the volume knob up a hair from zero - terrible hiss. At first I thought I had a lemon of a speaker so I tried swapping them. Same channel, different speaker - hiss. Only thing that solved it was turning the power off the transmitter.
Returning both units and just bought a Dynasty WSA-5RP. The speakers are a tough load on 50w @ 4ohm, but the rears are less than 3ft away from the MLP. The sub in/out will be nice down the road. Here’s to hoping because wireless rears are the only option for me.