Seeking help with a Threaded Banana Chassis Mount search

[Corn Fed HIFI]

Hi, looking for a replacement cage to chassis fastener for my Shuguang I-12 tube amp.
I have searched Pomona, Cinch, Keystone and Mueller offerings in hopes of finding an electrical connection banana plug that would suffice.
The banana shaped fasteners actually wobble +/- 2 degrees and have the following measurements: 25mm overall length, 5mm shoulder, 14 mm banana length, 3mm tip, 4mm banana width, 8mm nuts.
Open to suggestions.
Thanks!

 

[NTK]

Will this work?

https://www.newark.com/staubli/22-1053/connector-plug-50a-panel-mount/dp/40AH1736

There are similar ones you can find on AliExpress.

 

[DonH56]

You may be able to buy most any banana plug and replace whatever shell it comes with with a nut of the right size to turn it into a chassis mount.

 

[Corn Fed HIFI]

Will this work?

https://www.newark.com/staubli/22-1053/connector-plug-50a-panel-mount/dp/40AH1736

There are similar ones you can find on AliExpress.

Thanks for the suggestion but it is too wide for the female well on the chassis.
I will check AliEx

 

[Corn Fed HIFI]

You may be able to buy most any banana plug and replace whatever shell it comes with with a nut of the right size to turn it into a chassis mount.

Don, I tried four different bananas that I have on cables and they all too big at the "bulge".

 

[DonH56]

Don, I tried four different bananas that I have on cables and they all too big at the "bulge".

Ah, sorry. Too big to physically fit, or just too tight? Seems like might have been a special run just for Shuguang? Vexing...

 

[Corn Fed HIFI]

Ah, sorry. Too big to physically fit, or just too tight? Seems like might have been a special run just for Shuguang? Vexing...

Too big to physically fit although I may try cutting off one of the banana bulge strips ... nothing to lose