How to prevent USB connection error with DX7s & D50
Do not disconnect the USB cable while it is connected to the PC and the DX 7s is running.
However, there is no problem with D10.
Processing when connection between PC and DX 7s is broken. I am recovering by taking the following measures.
I am not confident that this recovery procedure is correct.
1. Shut down the PC.
2.Unplug the USB cable.
3.Turn off the power switch on the rear panel.
4.Unplug the AC cord.
5.Leave it for over 30 seconds.
6.Plug in the AC cord.
7. Turn on the rear panel power switch while pushing and holding the main knob.
8. Turn the main knob to select Factory Reset and execute it.
9.Connect USB cable to PC.
10.Turn on PC power switch.
When disconnecting / unplugging the USB cable, if you always shut down the PC, the error no longer appears
*The DX7s in box USB cable is the same product as the D10 and D50 in box USB cable.
*The USB cable I am using was purchased from Amazon.jp with 6$
Do not disconnect the USB cable while it is connected to the PC and the DX 7s is running.
However, there is no problem with D10.
Processing when connection between PC and DX 7s is broken. I am recovering by taking the following measures.
I am not confident that this recovery procedure is correct.
1. Shut down the PC.
2.Unplug the USB cable.
3.Turn off the power switch on the rear panel.
4.Unplug the AC cord.
5.Leave it for over 30 seconds.
6.Plug in the AC cord.
7. Turn on the rear panel power switch while pushing and holding the main knob.
8. Turn the main knob to select Factory Reset and execute it.
9.Connect USB cable to PC.
10.Turn on PC power switch.
When disconnecting / unplugging the USB cable, if you always shut down the PC, the error no longer appears
*The DX7s in box USB cable is the same product as the D10 and D50 in box USB cable.
*The USB cable I am using was purchased from Amazon.jp with 6$