HI all,
I'm building a NC500MP mono amp to power a Rel Britannia sub. I'll be using a MiniDSP Flex for crossover and DSP. Amp is almost together but I want to check-in to be sure I understand the singal wiring correctly. On the XLR to Hypex board(J4)connection I'm using shielded microphone cable. Is this the correct wiring?
BklynJim
I'm building a NC500MP mono amp to power a Rel Britannia sub. I'll be using a MiniDSP Flex for crossover and DSP. Amp is almost together but I want to check-in to be sure I understand the singal wiring correctly. On the XLR to Hypex board(J4)connection I'm using shielded microphone cable. Is this the correct wiring?
- Pin 1 on the XLR to case - close to the XLR,
- Pin 2 on XLR to pin 2 on H-box,
- Pin 3 on XLR to pin 1 on H-box,
- cable shield to case (not the same location as Pin 1),
- cable shield to Pin 3 on H-box.
BklynJim