Currently I am using just bare wire, which of course is fine but just not very practical when I want to move my amplifier (to clean or when I want to change the layout of the room) and my OCD makes me want to strip the wire once in a while (even though that would make no difference if you just screw them tight enough).
The speaker terminals on my amplifer (Marantz PM-16) are basically 2 flat plates that you screw together. There is no central screw that runs through them. When looking at them I thought I could take out the black things you see on the picture below, but they don't seem to removable. So what are my options here? I can push in a banana connector and tighten it, but that wouldn't be a great connection because of the 2 flat plates. I can't get spades in there either. So what can I do? Are there any connectors that are just a nice thick flat plate 5mm wide or so?
The speaker terminals on my amplifer (Marantz PM-16) are basically 2 flat plates that you screw together. There is no central screw that runs through them. When looking at them I thought I could take out the black things you see on the picture below, but they don't seem to removable. So what are my options here? I can push in a banana connector and tighten it, but that wouldn't be a great connection because of the 2 flat plates. I can't get spades in there either. So what can I do? Are there any connectors that are just a nice thick flat plate 5mm wide or so?