calibration

So, we (Sigberg Audio) have speakers and subs with built-in manual EQ, which is great - but we have many customers who doesn't know how to and/or doesn't want to learn how to use REW and a microphone to measure their system. Even though most here on ASR might find that to be "easy" and "worth...

Friends, I entered the calibration with my behringer umc 1820 sound card. Measurements were made starting from 125 Hz to 8000 Hz. Below are the measurement results for different headphones. behringer UMC1820 could not give me the results I wanted. So I researched a new sound card. Accordingly...

The other day I mentioned elsewhere this wonderful video by @OCA. It covers many topics but it has one little trick that is so genius that I think it deserves its own thread. In short it is to make Audyssey believe that there is nothing to correct about your speakers and your room. This turns...

Hello everyone! First time to the site. So, I just purchased and installed the Neumann KH120 and KH750 today and calibrated it over the network. Upon finishing the calibration and testing it….I’m not getting that much low end from the KH750. I’m hearing more low mids punch through the...

MiniDSP EARS: Affordable headphone measurement jig. Bought in 2018. Condition is very good. The silicone has yellowed a bit, but is still very flexible and tacky. The metal at the top has a bunch of tiny spots where the black coating went off and one slightly larger chip. I put some black tape...

Hi, The PeakTech P5055 SPL Meter has some kind of "internal calibration system (1 kHz sine wave generator)". Its manual contains the instruction: "Carefully adjust the sensitivity adjuster (8) with screw driver, until the display read within '94,0 +/- 0,2' dB". Normally microphones are inserted...

Although I've been using Umik1 for years, at first I always seem to have it right, but then the results end up driving me crazy with the same doubt: What combination of microphone positioning and calibration file gives us the real response our ears perceive at the listening point above the...

Okay! a controversial topic! can I ask why you guys say to put all crossovers on fronts centre and rear surrounds at 80hz? After I’ve run Audyssey on my Denon AVR-X2200, it always sets my Fronts, rears and centre at 40hz... I then always change them to 80hz as the recommendations, then I set...