I ran Audyssey XT32 MultiEQ on my Denon x3800h. Dynamic eq off, MultiEQ XT32 on Reference. I have 2 floorstanders, and dual 13" sealed subs in a 13.5x16x7.5 room - 1600 cu ft. The subs have limited placement options, partially due to room layout, partially to WAF. But I used Room SIM to try to get the best options within those confines. I then used REW to measure all xover points from 40 to 200 and found the "flattest" REW measurement was 100 so I set the xover to that. I applied 1/6 smoothing to get the measurement below. A few questions:
1. There's a rise between 30hz-40hz - what should I do about this if anything?
2. There's a dip between 80hz-200hz - is that speaker placement/room dynamics, or is there a setting I should change?
3. Same question about the rise between 200-500?
4. Anything else you would change in the system from this measurement?
TIA
1. There's a rise between 30hz-40hz - what should I do about this if anything?
2. There's a dip between 80hz-200hz - is that speaker placement/room dynamics, or is there a setting I should change?
3. Same question about the rise between 200-500?
4. Anything else you would change in the system from this measurement?
TIA
Last edited: