Hi all,
I would need a quick advice please. I'm slighltly improving my amp through cable routing amonst other optimisations. There's a trigger input on the chassis which is connected to both Ncore blocs as on the diagram below.
Question is what are the 2 resitors here for, on each ground line ? is that to make sure any ground current would try to find another easier path (such as the Chassis, assuming the blocs are also grounded to chassis, near XLR socket)
As I can't use these resistors from the original build, and I don't have same value at hand, can I use 1 KOhms instead ? (and how to decide which value is best, depending on what they are here for ?...)
Thx
I would need a quick advice please. I'm slighltly improving my amp through cable routing amonst other optimisations. There's a trigger input on the chassis which is connected to both Ncore blocs as on the diagram below.
Question is what are the 2 resitors here for, on each ground line ? is that to make sure any ground current would try to find another easier path (such as the Chassis, assuming the blocs are also grounded to chassis, near XLR socket)
As I can't use these resistors from the original build, and I don't have same value at hand, can I use 1 KOhms instead ? (and how to decide which value is best, depending on what they are here for ?...)
Thx