Nuyes

Looking forward to your review!

Today’s review focuses on the MV6, a speaker produced by Karak Electronics, a manufacturer better known under its official brand name...

Finally, yesterday, I completed the measurements. I measured a total of 25 speakers, including the manufacturer's reference sample. It...

I set it up temporarily and listened to it for a while to check for any initial glitches in the speaker. My first impression of both...

May The Force be with you. :p

I tested my new microphone holder today. It was a 5ms window @ 1m measurement, and the results are astonishing. No smoothing 1/12...

On the bright side, it would take about a month to get all those speakers on the NFS. :)

For the first time ever, I must face off against a dragon. The dragon wields the sharp teeth of NFS, while I am tasked with measuring...

I have never done any measurements that would intuitively show cabinet resonance, and I apologize for claiming that there is no...

This guide explains how to build a speaker with an aluminum enclosure. I designed the speaker using the waveguide for the SB26ADC made...

The CA5 was measured by @Nuyes using Klippel device. The measurements were as follows. More measurements and explanations of the...

They have an open listening room for music and movies, so I'm pretty sure they have experience with such situation :)

Thanks to ascilab, I added the A6B passive measurements to spinorama.org (here). Excellent speaker! Here a comparison to the mighty...

Wow! This is quite rigorous - hard to think of a way to give the measurements more credibility. Looking forward to the results.

Today I had chance to listen to their A6b active and C6b in Ascilab Korea's demo room. I have listened to early prototypes of C5b. But...