DanielT

As you may have noticed in my recent post, damping materials can affect bass tuning. Since it was built as supplied (no damping), made...

No difference if there is no ground loop current that can flow through the shields. There is a difference if ground loop current is...

I highly doubt there'll be any problems. I used to have the average hobby enthusiast homestudio, with 30 or more devices connected criss...

Sure, but there is nothing stated in that graph, as far as I can see, which dummy load Amir used. That's the point, FR changes depending...

Below is the impedance curve of OP's speakers (C-Note). The impedance magnitude of his speaker is 15 - 36 ohms from ~6 to 17 kHz, which...

Well, if you look at the graph in my #133 above. A 2 dB difference around 3.7 kHz is quite a lot. Where is the dishonesty in pointing...

There's definitely an issue with the amps I've used, proof is in the data. Orange audiosource, green aiyima a07

Theoretically, might make a difference with RF shielding. In reality, probably nothing anyone would hear in a blind test. The cable...

But if I were to do a blind test with my speakers with a load dependent class D amplifier vs a non load dependent amplifier what would...

Interesting that you do that. :) How did you come to choose semi-balanced RCA vs unbalanced ditto? Did you experience problems with...

I just put that video in for the sake of the picture. I am not interested in "High End" expensive cable. Sensible "standard" cables that...

I make all my interconnects this way and they work fine. If you have a long cable run - use balanced, assuming your gear supports this...

LOL. And only class AB can do this why?

Non-straight FR, load dependent, non-existent PFFB implementation exist for some (most of them?) TI TPA 32XX chip based amplifiers that...

I wouldn’t say it gets hot, warmer than some but not hot. I have a small quiet fan pointing down into the grill during the summer which...