GabrielPhoto
Senior Member
- Joined
- Jul 14, 2020
- Messages
- 408
- Likes
- 221
Hi!
So I just got a 1002 yesterday to replace the Aiyima 07 max I was using (two of them) to run two Dayton BST-300ex. I setup one shaker per channel (4ohm shakers).
Everything was doing great, better than the Aiyimas.
Today after doing some tests I went upstairs to do other stuff and then came back down a few hours later to keep testing.
Unfortunately this time, during the same test I was doing earlier (Godzilla vs Kong), the amp started to cut out and go into thermal protection during the bried demo scene. I ran the same scene MANY times almost back to back before while tuning the shakers via MiniDSP so not sure what happened here.
I swapped RCAs and Speaker cables too just in case but still the same.
This was an open box from Amazon but at least this didnt come up at all yesterday or today until now.
Maybe I got a lemon (maybe why it was returned?)
I may just go with the 1502 or the Xli1500 for extra headroom just in case.
Or just get an NX3000 which I have been pretty lucky with my other ones (a couple of nx6000D )
Thoughts?
PS I ordered the xli 1500 which seems to have a lot lore headroom if the Wilson audio tests in YouTube are accurate so if it's a case of pushing too hard, I hope that takes care of it.
So I just got a 1002 yesterday to replace the Aiyima 07 max I was using (two of them) to run two Dayton BST-300ex. I setup one shaker per channel (4ohm shakers).
Everything was doing great, better than the Aiyimas.
Today after doing some tests I went upstairs to do other stuff and then came back down a few hours later to keep testing.
Unfortunately this time, during the same test I was doing earlier (Godzilla vs Kong), the amp started to cut out and go into thermal protection during the bried demo scene. I ran the same scene MANY times almost back to back before while tuning the shakers via MiniDSP so not sure what happened here.
I swapped RCAs and Speaker cables too just in case but still the same.
This was an open box from Amazon but at least this didnt come up at all yesterday or today until now.
Maybe I got a lemon (maybe why it was returned?)
I may just go with the 1502 or the Xli1500 for extra headroom just in case.
Or just get an NX3000 which I have been pretty lucky with my other ones (a couple of nx6000D )
Thoughts?
PS I ordered the xli 1500 which seems to have a lot lore headroom if the Wilson audio tests in YouTube are accurate so if it's a case of pushing too hard, I hope that takes care of it.
Last edited: