vituixcad

Hi, i'm new to speaker building and wanted to understand a bit more about curves in vituixcad, to be precise i have this tang band w6 2100 and if i put it into a closed box of about 16 liters ( the vas of the driver is about 16 liters) i get this response ( black line in the SPL graph), but if i...

I am learning how to use VituixCad and have set up a project where the frequency response/impedance chart have been traced using the SPL trace tool. But no matter what values I set for the frequency reference points, or if I use log f axis, it has an incorrect frequency. Is this OK as long as...

I'm not active on this forum, so I apologize if this is old news, but I wanted to share an easy method to provide some EQ insight using the measurement data from ASR in VituixCAD. I started down this path having a few pairs of headphones that have been reviewed here or at least very similar to...

Hey, at the moment I am building a 2-way bluetooth speaker. I have to create a new crossover because I have annoying frequencies at around 2600hz I used this speakers: Dayton ND105-4 4" 60 - 10,000 Hz Dayton ND16FA-6 5/8'' 3,500 - 27,000 Hz At first I used Vituix CAD 1 to design a new...