topping dx1

  1. M

    Topping dx1 idle

    When I start PC topping DX1 light is muffled and keep phasing. And its not detected by PC. I have to take power cable out and plug it in again. It annoys a bit, any solution?
  2. tuanpekoe

    Headphone Amplifier for SMSL SU-1

    Hi everyone, I have been looking for my first DAC (or combo DAC/Pre-Amp) recently and found that SMSL SU-1 is highly recommended by some members. Because I am a newbie so I don't have much experience in this area. My purpose is quite simple, I want to listen to music by IEM headphone. And I...
  3. W

    What sample rate should use in Windows 11 with Topping DX1

    Hey I just got my first AMP DAC! I chose the Topping DX1, and I was just wondering what the best sample rate to use in windows 11 is? Thanks in advance :)
  4. A

    Topping DX1 bright treble issue

    Following the good reviews here and elsewhere, I decided to get a DX1. Most of the sound is great but I'm finding the extreme treble to be very bright. Tracks which are already bright, especially early '80s pop stuff, can sound almost unbearable. Does it just need a lot of time to break in or...
  5. S

    Topping DX1 Gain: L or H for Sennheiser HD 560S?

    Hi, I have a Topping DX1 which has a "Gain" switch on the back with options: L and H. I plan to buy Sennheiser HD 560S headphones tomorrow, which have the following specifications: Impedance: 120 Ohms Sound pressure level (SPL): 110 dB (1kHz, 1 Vrms) While Topping DX1 has the following...
  6. S

    Topping DX1 - Too Quiet (very low volume)

    Hi, I recently received Topping DX1. Today I connected it to my PC, installed the drivers (I'm using Windows 10). Then I connected headphones: Sennheiser PX 100-II (32 Ohms / 114 dB/mW) but the sound is weak compared to when connected directly to my PC (motherboard). For example, volume knob...
Back
Top Bottom