danadam

Re. 384 kHz, AFAICT, at this sampling rate the hardware usually switches to slow or early roll-off filters, although I only have RME...

:facepalm: I haven't even noticed :-) But wait, is it A? "What you are about to see is a direct comparison with measurements between...

https://www.audiosciencereview.com/forum/index.php?threads/rme-adi-2-dac-fs-akm-versus-ess-measurements-dac-preamp-headamp.35377/

The only thing that "hides" in the gaps is quantization error, which with dither is just noise. Stretching the gaps just increases the...

Horses like violin playing :-)

Not sure I understand. A change from half of FS to FS is just 1 bit. If you have a signal at half of FS in 16-bit format, that's 15-bits...

Wasn't delta-sigma architecture becoming more popular in general, regardless of what format (PCM or DSD) was delivered to the end-user...

-6 dB at 10k with 20k transition band. It was SoX's "sinc -M -a140 -t20k -10k". The full command was: sox -r384k -n imp.wav synth 1 sq...

Here is a pulse with 2.6 µs shift between channels played through a few DACs...

There is a subtle detail that may be not so obvious (or maybe it wasn't only to me :-) ) When we say that we have this or that many...

Another way to look at bit-depth for those heads that are spinning on "dynamic range" vs. "resolution"... it's kind of two ways of...

Apparently DECCA had a 18-bit/48 kHz system in 1979 :-) https://www.vtoldboys.com/NEW_VPR5_SITE/Decca_1.html Sony manufactured 24-bit...

90% of people prefer speakers with a flat response. All audiophiles: ”I’m part of the 10%”. 1% of people can distinguish high res...

I don't quite understand your point. Antialiasing filters also exist when resampling. The image is conceptually a spatially continuous...

Just fyi... The length is already known from "synth", so starting time of the fade out can be 0 and it will be calculated from the fade...