D!sco

Forgot to include the final picture of how the system looks like: Note: it is not the very final state since the high gloss piano...

I am now the proud owner of a Gaggiuino! After a four and a half hour battle with my wiring, bolts and a wire routing error which caused...

I just had some time now to perform some measurements and finish the integration of the sub All the below measurements were done at MLP...

The speaker is 90% done, see the photos about the progress below: I have done some tests to see if the cabinet is airtight and...

Well, curiosity got the better of me and I ordered dual PSA TV2112Ms. Here is where they ended up after positioning and running through...

Today the drivers have finally arrived! Both of them work fine, just tested them Next week I will finish the cabinet (probably...

I really appreciate the suggestions. I may try printing a throat mount for the calibration mic someday for fun anyways. A horn should...

If you're looking for a great value voice microphone, I'm a massive fan of the Micbooster Clippy lav mic. It's omnidirectional too, so...

Big oof

Note to self, never discuss saving money at ASR. :p

The UMIK has a lot of hiss and being omnidirectional, will pick up noise from all over your room. If you have like a keyboard and mouse...

Being a fairly inexperienced amp "designer" I have lots of questions so I would like to measure several variations of the amp...

Shots below of my working amp in Frankenstein case, some pieces not shown (fans & prototype raspberry pi controller ... I am working on...

Major System Components (I will provide links to each part and price after I finalize the design this is still evolving) 2 power...

Update: I have the amplifier up and running, although at the moment this is inside a "Frankenstein" temporary case (an old Denon AVR)...