Snafu

I will measure them without the plate first, then put back the plate without the plugs and measure that as well. I'll be back.

are You able to remove these and try with bottom plate on ?

Because of the price of these speakers, that's most logical thing to do from Wharfedale. Isn't it better than someone checks them out in...

@dcolak So, what was the outcome ? Were you able to fix this issue.

About those blocks, can't see well from the pictures how they are installed, but could they be transport supports and should be removed...

Yes, R&D and assembly of their TOTL models is done there, had the luck to visit it 7 years ago, here is a factory tour video from 2023:

The Blades and Reference Series are meticulously assembled and tested in England:

And they look like a trash can...

None of my KEF speakers have poor center image ? it's pinpoint and precise in fact the whole soundscape seems to sound the same L to R ...

Any imbalance will effect the imagining, regardless of if it comes from the DAC, preamp, amp or speakers.

Could this be caused by uneven measuring speakers in pairs? Years ago i bought Duntech speakers and manufacturer said that these...

Pretty much same in most threads. After 3-4 posts thread is gone off the subject in matter.

Fyne updates their 500-series, so not completely new but if F502S is closer to F502SP it might have a sweet spot in price/sound...

Thanks, I guess with those it should sound at least so good that it doesn't sound "wrong".

Mark levenson amp and preamp with 150watts into 8 ohms. I doubt more power would make them image dramatically more.