Recent content by Schackmannen

What ref level are you using?

@amirm For the dashboard, wouldn't it be better to display just THD without noise? Also what exactly is the gain figure measuring?

The same thing happens to my unit but I always use the remote to change the volume anyways so it doesn't botter me at all.

I'm definitely interested then, but I will probably need to wait until I get my salary on tuesday. Hopefully they won't be gone by then :p

Roughly how much would it cost to ship them to Sweden?

Here's some info about it all

A smooth capacitor? :p

I leave it on because I like to watch the spectrum display sometimes :)

@amirm Could you please do the multitone and THD+N vs Freq test?

@amirm Just to confirm, was the 50 mV SNR test done with the IEM port and not the 1/4-inch output? It's mostly academic, but the IEM output should have lower noise than what the AP can measure.

Maybe @MC_RME can shed some light on the issue?

I don't know about you, but to me there is a huge difference between 1.3 million and 65000 deaths (factor 20 less). As to why it matters it's difficult to discuss without getting political.

If I remember corrctly I experienced something similar with my ADI-2 DAC connected to the balanced inputs of my THX 789. When the amp was on and the DAC was off (red ring) I could hear a buzz, but as soon as I turned on the DAC it disappeared. Not sure why it happened, but it wasn't an issue...

It's been a while since I watched the video and don't have time to watch it again right now, but IIRC the guy, who worked for AP at the time (and is a member here but forgot his username), mostly talked about specs that are not properly stated are pretty much meaningless, like if an amp is...

I definitely agree, and it's quite subtle as well so I can't really see it being that distracting.