MC_RME

There is a fixed DC filter (very low) plus a pre-configured 'Rumble' filter as preset which consists of a 5-band PEQ and can be adjusted...

https://www.aliexpress.us/item/3256804517239605.html I used this when I was curious since I have the DCA E3 & RME ADI-2/4 Pro SE and...

Correct. The trick works with ADAT input signal, as there the sample rate is not strictly indicated. But with SPDIF/AES it is, so the...

No, you are right. It depends on the volume set at the ADI.

No, all is correct, DSD256 is supported only in NATIVE mode. In DoP mode DSD is encapsulated into a PCM stream doubling the data rate...

This one looks like a nice closed alternative to my open Edition XS. Unfortunately I have to pass it for now as the dummer 4.4 mm cable...

Does it have a lightbulb? Or is it 'Lightning'? ;)

Thank you so much for the review @amirm, I already knew the fantastic behavior of this little kid thanks to @staticV3 and proudly own...

And that impedance detect quirk is the exact reason the Tempotec Sonata HD Pro that I bought after the ASR review, and equipped with...

You should first measure the connection from DC barrel ground to AC PE. It might be that PE is only used on the primary side inside the...

Sorry for the little OT, but just wanted to say that the Kuang Pai made me check in details the buzzing noise issue I mentioned earlier...

It might just miss the ground.

The Kuang Pai Player 3 arrived today, and despite the different implementation, it ended up using the same Savitech usb bridge than DS2...

IEC 60958-3-2006 added proper channel status for 192 kHz in 'Domestic S/PDIF' in 2006, but 192 kHz was used before that already...

There have been other CS based units measured on ASR and most show much better results than the data sheet. Apart from that we don't...