Lambda

Ah! I missed this distinction. Will see if I can remeasure tonight.

I think this looks nice and the others look like some esoteric BS to pretend they do some voodo magic.

Big test of 13 op-amps in inverting configuration with gain = -1 This post focuses on distortion as it is often not well specified for...

I set the gain (volume) as close as I can to 25 dB. This in general allows full power to be reached at 2 volts for unbalanced and 4...

@amirm waht is the reason for the volume "gain" setting of 66/70? to get ~24dB gain? to get max power at 4Vrms?

How and why Was the combination of Volume setting and input voltage chosen? It would be interesting to see how Higher input voltage and...

Why even look at 1000€ stuff if 25€ stuff used right is more then good enough? Why not look deeper at extensive stuff if a view...

I must say i enjoy this deep dives in quirks and edge cases of a device way more then just comparing SINAD numbers that are (if they are...

And yet somehow I manage to get reliable, clear, loud and consistent, without clipping, vocals for radio broadcast every day. Without...

i’m not saying it has been solved. it can be solved. and now it’s easier, and cheaper then ever. It still needs some amount of effort...

And somehow we do this since may decades. You don’t need any fancy proprietary "clip guard" or dual DAC like zoom. if you just keep the...

So if you only have one microphone just set the gain right and Compress in software. Almost any interface will do. (waht mic do you...

Should be possible to do this in real time in software, running through a DAW, and then using loopback recording to stream the output...

The X32rack is absolutely overkill for the job! it dose not need "the best components" to be absolutely fine for this simple job. A...

Here we go. Dense multitone, periodic (512 samples), linear spacing of ~100Hz, spanning ~100Hz ... 12kHz, pink spectrum, RMS level of...