Recent content by JStewart

The shape of the bass roll off has me wondering what you would have subjectively thought if it closer to the wall behind it an no bass boost filter.

Even so, please tell Hobie and Dirac we’re ready! :p TBH I would gladly pay for a beta version at this point!

Please tell Hobie we’re ready!

Do they have kids sizes?

Hey @TimoJ . Thanks for all your help and support for HTP-1 owners and Dirac. Amir said this about jitter on HTP-1 ”Wish I could test HDMI but can not. Above spikes are correlated with the 250 Hz square wave that is embedded in J-test signal. This means what bits to feed the DAC changes its...

This just doesn’t seem right at all I found a familiar muting problem I have seen below -90 dB in other processors: I ran this by Anthem but they could not replicate it. They shared measurements with me that was normal. I have supplied my test project file for them to investigate. Will...

Flavio said they had an ”intrusion” and are working on it. https://www.avsforum.com/threads/dirac-live.3137722/post-62937097

Are you one of the lucky HTP-1 Beta testers?

James Larson over at Audioholics.

To expand on prior post http://www.roomeqwizard.com/help/help_en-GB/html/makingmeasurements.html#fileplayback

According to the manual with only the 6ohm Elacs connected Yamaha recommends the High setting. If you want to know more about what that switch is actually for and doing there’s this: https://www.audioholics.com/audio-amplifier/impedance-selector-switch-1 Great speakers. I have a pair and...

Just checked and AStock shows available. There‘s also a $750 off coupon that may work if anyone has a mind to try. https://www.monoprice.com/pages/back_to_school?page_type=homepage%20&location_type=leaderboardr0s1&start_date=230815&promo_type=230814_backtoschool $3250 is still a decent deal...

I’ll preface this question by stating I’m no expert in this. Could at least the lowest peak be caused by noise in the circuitry? It seems suspiciously close to 2nd harmonic of 60Hz electric frequency. Whatever it is, it’s ringing like crazy. Good luck.

From REW help file: Using a timing reference allows REW to eliminate the variable propagation delays within the computer and interface so that separate measurements have the same absolute timing. Or put another way, using a timing reference overcomes the fact that your computer sometimes thinks...